As part of its accreditation NC-5 operates on the following main areas:

  • performance of acceptance, standard, periodic testing of technical parameters by means of EMC;
  • rendering services to companies and organizations for integrated certification testing of a wide range of products in various industries for the EMC requirements;
  • development of methods of testing and advising pre-dpriyatiyam and organizations on EMC;
  • metrological certification of antennas.


There is the possibility of testing at customer solutions for EMC problems

Certification tests are carried out according to the following aggregated types of hardware:

  • motor vehicles or other devices powered by internal combustion engines;consumer electronic equipment;
  • articles and equipment for industrial, transport and energy use;
  • electronic products;
  • power lines and power stations;
  • industrial, scientific, medical and domestic high frequency;electronic warfare;
  • data processing equipment and computer science;
  • measuring instruments;
  • television and video equipment;
  • wired communication device and data;
  • electrorolling composition of urban land and rail transport;
  • electrical and radio household and medical supplies;antenna.

Types of tests 

Βasic Standard

Measuring the voltage conducted disturbances in the frequency range of 9 kHz to 30 MHz,

Power measurement of industrial noise in the frequency range from 30 MHz to 1000 MHz,

The field strength measurement of the industrial interference in the frequency range from 80 MHz to 3 GHz 

DSTU CISPR 16-2:2005
DSTU CISPR 22:2007
IEC 61000-4-20:2007

Hardware tests for resistance to Nome radio frequency electromagnetic fields in the frequency range from 80 MHz to 3 GHz

DSTU IEC 61000-4-3:2007
IEC 61000-4-20:2007
DSTU CISPR 16-2:2005

Metrological certification of antennas in the frequency range from 0.009 MHz to 3 GHz

ГОСТ 8.363-79
ГОСТ 8.463-82

EMC testing of vehicle are carried out using an automated test system bathroom, operating under the control of the specialized software (SW) R & S ® EMC32, design firms, we Rohde & Schwarz (Fig. 1). 

Figure 1 - Test Receiver R & S ESCI and PC (system unit is not shown in the photo) with software R & S ® EMC32.

Figure 2 - Stand with generatoramplifier and RF devicesremote control.

The basis of the test system is the most modern equip-ment are leading in the field of international firms, such as Rohde & Schwarz, TESEQ (formerly Schaffner), BONN Electronik, RF / Microwave Instrumentation, MATURO (Figure 1-4).

In particular, unique for Ukraine, seven-meter test chamber GTEM 1500 TESEQ GTEM (Gigahertz Transverse Electro-Magnetic test cell - test chamber transverse electromagnetic waves gigahertz frequency range) (Fig. 4) allows testing of the vehicle to interference emission and immunity according to international standards IEC / EN 61000-4-3, IEC / EN 61000-4-20, IEC / EN 55022 and others in the frequency range from zero to 20 GHz.

Figure 3 - The absorbing clamp R & S MDS21 on an automated guide rail.

Figure 4 - Test GTEM cell TESEQ GTEM 1500 with the door open.

All existing equipment, including radio-frequency cables with normalized metrological characteristics, passed calibration procedure in the civil service DKD calibration Germany and has the relevant international certifications.

NC-5 has a developed legal and technical facilities and trained staff to continually improve their skills.