Certificate of the Ministry of Education and Science of Ukraine Ser. DR No. 02702 of August 21, 2019. The National Science Center "Institute of Metrology" is listed in the State Register of Scientific Supported Institutions.
Note! On July 3, 2019, in accordance with the Law of Ukraine of 06.06.2019 No. 2740-VIII "On Amending Certain Legislative Acts of Ukraine Regarding the Implementation of Legislation of the European Union in the Field of Technical Regulation", the possibility of "verification of measuring instruments that are not applicable in the field legislatively regulated metrology, on a voluntary basis".
Order No. 1428 of 10.05.2018 "On expansion of the scope of the body for the assessment of compliance with the requirements of the relevant technical regulation" - Technical regulation of the legislative regulated means of measuring equipment, approved by the Resolution of the Cabinet of Ministers of Ukraine dated January 13, 2016 No. 94, designated by the Ministry of Economic Development Decree of January 31, 109 "On the appointment of a conformity assessment body to carry out an assessment of compliance with the requirements of the relevant technical regulation" by the conformity assessment body for the assessment of compliance with the requirements of the the technical regulations.
Order №1216 of 25.07.2016 "On the appointment of conformity assessment requirements of the relevant technical regulation" - Technical Regulations of measuring instruments approved by the Cabinet of Ministers of Ukraine of 24.02.2016 №163, with an assigned identification number UA.TR.113
Order №1164 of 14.07.2016 "On the appointment of conformity assessment requirements of the relevant technical regulation" - Technical regulation on non-automatic weighing instruments approved by the Cabinet of Ministers of Ukraine of 16.12.2015 №1062, with an assigned identification number UA.TR.113
Order #553 of 16.05.2014 р. "On credentials (certification) of the National Scientific Center "Institute of Metrology" to conduct public acceptance testing, calibration of measuring equipment, validation of measurement techniques used in the field of state metrological control and measurements in the field and/or outside the sphere of state metrological supervision"
