Home» Struct» Subdivision» State Testing Center "Metrology"

Certificate of recognition of QSF-R86 quality management system in accordance with ISO / IEC 17025

Based on the decision of the 29th meeting of the Technical Committee of the COOMET Quality Forum, a Certificate of Recognition QSF-R86 of the quality management system of NSC "Institute of Metrology" was issued in accordance with ISO / IEC 17025 dated September 30, 2021.

The certificate is issued for the following types of measurements: Length, Thermometry, Electricity and magnetism, Time and frequency, Mass and related quantities, Ionizing measurements and radioactivity, Photometry and radiometry.

This Confirmation is valid until September 30, 2026

The National Testing Centre “Metrology” is established and functions as the structural subdivision of NSC “Institute of metrology” for the purpose of carrying out testing in the fixed field of accreditation.

The National Testing Centre “Metrology” is accredited by the National Accreditation Agency of Ukraine (Certificate of Accreditation registered in the Register of November 15, 2020 under number 20524, valid until November 16, 2025)

In its general activity the National Testing Centre “Metrology” is guided by the Statute on the National Testing Centre “Metrology” approved by the National Accreditation Agency of Ukraine, and in the field of services quality provided to Customer – “Quality Guidance”, developed in accordance with Regulations ДСТУ ISO/IEC 17025:2017.

NTC “Metrology” provides the following kinds of services:

  • product testing;
  • developing the new testing methods;
  • providing consulting services, etc.

National Testing Centre “Metrology” in accordance with the requirements of ДСТУ ISO/IEC 17025:2017 (ISO/IEC 17025:2017) conducts the following tests:

household and similar equipment and components; lighting products and components for it; computer equipment; medical equipment; wires; electrical and electronic equipment; control and measuring equipment; power transformers; radiation and laser equipment; means of protection; information technology and software.

National Testing Centre “Metrology” performs product testing on characteristics of safety and quality in the following areas:

  • definition elektrychnoyii security products and mechanical and climatic tests;
  • characterization of ionizing radiation;
  • linear-angular measurement;
  • determine electromagnetic compatibility;
  • vibroacoustic parameters measurement products;
  • optical and physical measurements.